Search found 5 matches
- Sun Feb 19, 2017 7:44 am
- Forum: General Discussion and Tips
- Topic: How to change the initial starting position of the extruder?
- Replies: 2
- Views: 2738
- Jump to post
Re: How to change the initial starting position of the extru
Thank you! I just around to trying this out now. Kept the Y value as is, and changed the x value to -1. And now it purges just off the plate. Thanks again
- Thu Feb 16, 2017 7:50 am
- Forum: General Discussion and Tips
- Topic: Suggestion on best setting for thin wall print
- Replies: 2
- Views: 1757
- Jump to post
Re: Suggestion on best setting for thin wall print
Wow, I didn't expect 'the' Brian I quoted from that other thread. Thank you. I had slowed all my speeds down, but will now just try slowing just the infill speed. And I'll try the other suggestion tomorrow. Thanks again, Ryan.
- Wed Feb 15, 2017 3:30 am
- Forum: General Discussion and Tips
- Topic: Suggestion on best setting for thin wall print
- Replies: 2
- Views: 1757
- Jump to post
Suggestion on best setting for thin wall print
"When I select "Allow gap fill when necessary", my print comes out fine with filled-in gaps. But because my print is made up of lots of thin walls, my printer shakes back and forth on the table while filling in many of these gaps. http://i68.tinypic.com/orm3oz.jpg http://i68.tinypic.c...
- Mon Jan 30, 2017 5:11 am
- Forum: General Discussion and Tips
- Topic: ......
- Replies: 1
- Views: 523
- Jump to post
......
......
- Mon Jan 16, 2017 5:26 am
- Forum: General Discussion and Tips
- Topic: How to change the initial starting position of the extruder?
- Replies: 2
- Views: 2738
- Jump to post
How to change the initial starting position of the extruder?
I have an Ultimaker 2 Go. At the beginning of each print, before making the skirt, the extruder extrudes some filament over one corner of my build plate. This initial extrusion forms a little mound of filament and unless I grab it, a thin strand stays stuck to the nozzle, and it pulls this little mo...
