Search found 5 matches

Go to advanced search

by sjanssen
Tue May 28, 2019 2:32 am
Forum: Troubleshooting and Bug Reports
Topic: bigrep settings
Replies: 0
Views: 367

bigrep settings

Hi there,

the bigrep ONE is listed as a supported printer, but I don't see it in the configuration assistant. Does anyone know how to set up this printer?

Cheers,
Steven
by sjanssen
Tue Apr 25, 2017 8:15 pm
Forum: Troubleshooting and Bug Reports
Topic: Infill Angle Offsets Behaviour
Replies: 3
Views: 2001

Re: Infill Angle Offsets Behaviour

Yep, I have changed the settings and fixed the issue, but my point was more that this setting is handled differently in different versions of S3D, as per my 3rd screenshot.
by sjanssen
Mon Apr 24, 2017 12:22 am
Forum: Troubleshooting and Bug Reports
Topic: Infill Angle Offsets Behaviour
Replies: 3
Views: 2001

Infill Angle Offsets Behaviour

Hello, we have just noticed a change in the way the Infill Angle Offsets are handled in S3D 3.1.1 compared to older versions (3.0.2). We previously had settings as in the attached image: Rectilinear with angles of -45, 45, which meant the first capping layer was printed at 90 degrees to the infill l...
by sjanssen
Mon Jan 30, 2017 12:45 am
Forum: Troubleshooting and Bug Reports
Topic: Three bugs
Replies: 2
Views: 487

Re: Three bugs

Thanks for the useful info, Brian!
by sjanssen
Tue Jan 24, 2017 1:06 am
Forum: Troubleshooting and Bug Reports
Topic: Three bugs
Replies: 2
Views: 487

Three bugs

Hi there, I emailed support about a couple of these bugs already, but thought I'd provide a bit more detail here and see if anyone else has seen these: 1. In the Temperature tab in the FFF settings, if you remove the only temp. controller it says "No Temperature Controllers Present". This removes th...

Go to advanced search