Hi there,
the bigrep ONE is listed as a supported printer, but I don't see it in the configuration assistant. Does anyone know how to set up this printer?
Cheers,
Steven
Search found 5 matches
- Tue May 28, 2019 2:32 am
- Forum: Troubleshooting and Bug Reports
- Topic: bigrep settings
- Replies: 0
- Views: 780
- Jump to post
- Tue Apr 25, 2017 8:15 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Infill Angle Offsets Behaviour
- Replies: 3
- Views: 3107
- Jump to post
Re: Infill Angle Offsets Behaviour
Yep, I have changed the settings and fixed the issue, but my point was more that this setting is handled differently in different versions of S3D, as per my 3rd screenshot.
- Mon Apr 24, 2017 12:22 am
- Forum: Troubleshooting and Bug Reports
- Topic: Infill Angle Offsets Behaviour
- Replies: 3
- Views: 3107
- Jump to post
Infill Angle Offsets Behaviour
Hello, we have just noticed a change in the way the Infill Angle Offsets are handled in S3D 3.1.1 compared to older versions (3.0.2). We previously had settings as in the attached image: Rectilinear with angles of -45, 45, which meant the first capping layer was printed at 90 degrees to the infill l...
- Mon Jan 30, 2017 12:45 am
- Forum: Troubleshooting and Bug Reports
- Topic: Three bugs
- Replies: 2
- Views: 978
- Jump to post
Re: Three bugs
Thanks for the useful info, Brian!
- Tue Jan 24, 2017 1:06 am
- Forum: Troubleshooting and Bug Reports
- Topic: Three bugs
- Replies: 2
- Views: 978
- Jump to post
Three bugs
Hi there, I emailed support about a couple of these bugs already, but thought I'd provide a bit more detail here and see if anyone else has seen these: 1. In the Temperature tab in the FFF settings, if you remove the only temp. controller it says "No Temperature Controllers Present". This ...
