Simplify3D User Forum

advancedrescue

Ok tomorrow we will attempt some more but didn't go as planned so far. Yesterday we added the second extruder in the fff settings. set diam etc. Set the second extruder to do the infill and the support material. Attempted to print and immediately saw it wasn't heating(which has been figured out why)...

advancedrescue

I've got a cubepro, but have recently put the duet wifi board in it, and installed duel e3d volcanos. I'd like to have the basic functions and start up and end routine of the cubepro tho. For instance: At beginning of print job -extruder move to waste bin --get up to target temp ---extrude ----exit ...

advancedrescue

Sure. Setup both extruders with the different nozzle diameters, then set the primary extruder to the 0.4mm one so that will be used for the outlines, and set the infill extruder to the 0.8mm one. So now the outlines will be printed with the smaller nozzle, and the infill with the thick one. If you ...

advancedrescue

Hey guys, I'm new to using simplified and doing ok figuring out the basics. I just had an idea, and perhaps it's been done or discussed. I'll try my best to describe in detail what I'm wondering about. I'd like to use both of my E3D volcano extruders on the same print job, both being heated up and r...

Search found 4 matches

Re: Dual extruders printing w/diff diam nozzles

Re: Alternative to CodeX for CubePro/CubeX printer

Re: Dual extruders printing w/diff diam nozzles

Dual extruders printing w/diff diam nozzles