Search found 3 matches
- Mon Jan 29, 2018 3:55 pm
- Forum: General Discussion and Tips
- Topic: Printer profile changes
- Replies: 2
- Views: 7398
- Jump to post
Printer profile changes
I often use a printers profile as a start and then make changes to it over time. Today S3D informed me that the profile had an update, great. I saved it as a new profile and then went about looking for differences. This would have been a lot easier if there had been release notes or a changelog that...
- Mon Jan 29, 2018 3:51 pm
- Forum: General Discussion and Tips
- Topic: Creality CR10 Speed
- Replies: 5
- Views: 7982
- Jump to post
Re: Creality CR10 Speed
upload your gcode file and we can see if its the printer or s3d
- Mon Feb 06, 2017 8:04 am
- Forum: Troubleshooting and Bug Reports
- Topic: Odd layer banding on side of prints
- Replies: 10
- Views: 12197
- Jump to post
Re: Odd layer banding on side of prints
Old post I know. If the printer is a Prusa I3 or similar setup with lead screws or more likely threaded rod for the Z axis I would suggest that this banding may be caused by a bent screw. If you have guides at the top of the screws connecting them to the frame either remove them or widen the holes. ...
