Search found 3 matches
- Fri Feb 17, 2017 9:59 am
- Forum: Troubleshooting and Bug Reports
- Topic: Simplify3D Won't Launch Properly
- Replies: 26
- Views: 19453
- Jump to post
Re: Simplify3D Won't Launch Properly
Simplyfy3D locks up routinely. Other times it won't start. After waiting, if I click run again and go to Task Manager I can see several instances with no activity and it never loads. I have to reboot PC to get it to work. All other software on PC working fine; Office, Outlook, Explorer etc. OS Windo...
- Wed Feb 08, 2017 12:47 pm
- Forum: Troubleshooting and Bug Reports
- Topic: First layer Height Width no changing extruder flow
- Replies: 3
- Views: 4588
- Jump to post
Re: First layer Height Width no changing extruder flow
Brian, Thank you very much for your detailed response. I did have the three factors that you listed causing the first layer gap issue. After a little filament calibration, Extruder Magnification adjustment and additional bed leveling I can see the proportional adjustment of the extruder flow and fin...
- Tue Feb 07, 2017 11:53 am
- Forum: Troubleshooting and Bug Reports
- Topic: First layer Height Width no changing extruder flow
- Replies: 3
- Views: 4588
- Jump to post
First layer Height Width no changing extruder flow
Three first layer issues that I am experiencing: 1) First layer height have read does not affect extruder flow rate. It is suggested for better bed adhesion to lower Height to 90%, thus same extruder flow going into a tighter height results in the bead to spread on the bed. But also read that settin...
