Search found 2 matches

Go to advanced search

by pekwalker
Wed May 23, 2018 2:07 pm
Forum: Troubleshooting and Bug Reports
Topic: Failure with first layer
Replies: 2
Views: 448

Failure with first layer

When I start to print a model with Simplify3D, the extruder nozzle for some reason starts pushed too close to the print surface as if the software is trying to push it down. No filament comes out and the nozzle is cutting into my print surface. I have tried adjusting the Layer Settings > First Layer...
by pekwalker
Wed Feb 15, 2017 1:59 pm
Forum: General Discussion and Tips
Topic: Tip of the Day 10- Extruder tab, a technical analysis
Replies: 14
Views: 125686

Re: Tip of the Day 10- Extruder tab, a technical analysis

I am new to 3D Printing and this is my first time using Simplify 3D. In another program I had used before, there was an option called retract before move. I can not find that option in Simplify 3D and was wondering if someone could tell me what the equivalent in this program is or where I could find...

Go to advanced search