Search found 2 matches
- Wed May 23, 2018 2:07 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Failure with first layer
- Replies: 2
- Views: 1564
- Jump to post
Failure with first layer
When I start to print a model with Simplify3D, the extruder nozzle for some reason starts pushed too close to the print surface as if the software is trying to push it down. No filament comes out and the nozzle is cutting into my print surface. I have tried adjusting the Layer Settings > First Layer...
- Wed Feb 15, 2017 1:59 pm
- Forum: General Discussion and Tips
- Topic: Tip of the Day 10- Extruder tab, a technical analysis
- Replies: 14
- Views: 173111
- Jump to post
Re: Tip of the Day 10- Extruder tab, a technical analysis
I am new to 3D Printing and this is my first time using Simplify 3D. In another program I had used before, there was an option called retract before move. I can not find that option in Simplify 3D and was wondering if someone could tell me what the equivalent in this program is or where I could find...
