Search found 7 matches
- Mon Jul 17, 2017 4:03 pm
- Forum: General Discussion and Tips
- Topic: How To Cut Apart Large Objects
- Replies: 9
- Views: 32037
- Jump to post
Re: How To Cut Apart Large Objects
Hi guys, My work flow for very large objects that I did not design (otherwise I would just use Zbrush/Solidworks/etc), includes mesh mixer. It keeps the sizes the same (unlike zbrush), so I like to use it. Look up "spliting stl in meshmixer" on youtube and you should get a few hits. I can'...
- Tue Jul 11, 2017 10:19 pm
- Forum: Troubleshooting and Bug Reports
- Topic: [BUG] Pause Issue
- Replies: 1
- Views: 1333
- Jump to post
[BUG] Pause Issue
I am somewhat upset right now so I'll keep this brief: -I was unable to pause print using the 'Pause' button in the 'machine control panel' window in order to put more filament in. -Printing using the 'Begin Printing Over USB' button. -Connected and everything was showing up properly on 'Machine Con...
- Tue Jul 11, 2017 3:48 pm
- Forum: General Discussion and Tips
- Topic: Printing stops before part is complete
- Replies: 5
- Views: 3369
- Jump to post
Re: Printing stops before part is complete
I'm not sure what 4 scenarios you mean on the FAQ but it sounds like it's a USB interruption (at least that's what was happening to me). Even if you're printing off an SD card you need to have the USB port that's connected to the printer be active for the entirety of the print. You will have to chec...
- Fri Jun 23, 2017 6:04 pm
- Forum: General Discussion and Tips
- Topic: Need some tips & help calibrating my retraction (Pictures)
- Replies: 2
- Views: 7878
- Jump to post
Re: Need some tips & help calibrating my retraction (Picture
You should probably keep settings from your second attempt and start changing your travel/print speeds. What's worked for me is to increase the travel speed and slow the print speed (although it looks like your print speed is fine).
- Mon Jun 19, 2017 7:24 pm
- Forum: General Discussion and Tips
- Topic: Possible overheating - sagging/drooping on overhang
- Replies: 4
- Views: 5886
- Jump to post
Re: Possible overheating - sagging/drooping on overhang
For me, enabling coasting fixed most of the blobs. I would suggest enabling that first at 0.2 mm and seeing if it helps/fixes the issue.
- Wed Jun 07, 2017 3:36 pm
- Forum: General Discussion and Tips
- Topic: Pimple prints
- Replies: 2
- Views: 1385
- Jump to post
Re: Pimple prints
I had a similar problem and fixed it by enabled coasting with the settings on the troubleshooting FAQ
- Mon Feb 27, 2017 7:02 pm
- Forum: General Discussion and Tips
- Topic: Top layer problem with small details
- Replies: 18
- Views: 8758
- Jump to post
Re: Top layer problem with small details
Insufficient cooling. Try one or more of the following suggestions: -Print and install a new fan duct to improve cooling. -Print multiple bulbasaurs at once in order to give each layer more time to cool and prevent the nozzle from warping layers -Put a fan next to printer to increase air flow over p...
