Search found 5 matches
- Wed Jun 21, 2017 7:39 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Print shifting - Both X and Y
- Replies: 5
- Views: 2824
- Jump to post
Re: Print shifting - Both X and Y
Here's the finished print run.
- Wed Jun 21, 2017 8:52 am
- Forum: Troubleshooting and Bug Reports
- Topic: Print shifting - Both X and Y
- Replies: 5
- Views: 2824
- Jump to post
Re: Print shifting - Both X and Y
Read the Troubleshooting Tips, made some changes and printed a model that I'm very satisfied with. I'll post a GOOD photo this evening. 1) Rebooted everything 2) Checked lock screws, all seemed tight. Did tighten up belt tension slightly. 3) Slowed printing speed to 75% 4) Print ran over 18 hours+ w...
- Tue Jun 20, 2017 7:40 am
- Forum: Troubleshooting and Bug Reports
- Topic: Print shifting - Both X and Y
- Replies: 5
- Views: 2824
- Jump to post
Re: Print shifting - Both X and Y
Read it long ago before I was having trouble and forgot to go back and look, thanks for the reminder.
- Sun Jun 18, 2017 9:26 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Print shifting - Both X and Y
- Replies: 5
- Views: 2824
- Jump to post
Print shifting - Both X and Y
Hi, I've been printing everything in PETG these last few months and successfully, once I fully appreciated the importance of keeping my filament dry. Last night I loaded my biggest file ever, using 7.5" of my MakerGear table in the "X" dimension. After many layers (not sure of the cou...
- Sun Mar 05, 2017 5:23 pm
- Forum: General Discussion and Tips
- Topic: Bed preheat / Extruder Temp
- Replies: 1
- Views: 1554
- Jump to post
Bed preheat / Extruder Temp
Hello, I've been printing PETG parts (MakerGear M2) that I'm very happy with but am confused about something that seems very basic though still continue to stumble with. A cold start, I load my STL file, Prepare to print and then Print. A message appears....."Preheating Bed..." I open the ...
