Search found 3 matches
- Sat Sep 09, 2017 12:00 am
- Forum: Feature Requests
- Topic: Improvement to "Avoid crossing outline for travel movements"
- Replies: 11
- Views: 17417
- Jump to post
Improvement to "Avoid crossing outline for travel movements"
I'm printing something in flexible TPU material, which is especially susceptible to oozing/stringing. It's a protective sleeve for a device to slide into, and I was trying to reduce the amount of cleanup on the interior I needed to do after printing. Turning on "Avoid crossing outline for trave...
- Sun Jul 23, 2017 11:58 am
- Forum: General Discussion and Tips
- Topic: Questions about multiple processes
- Replies: 2
- Views: 1835
- Jump to post
Questions about multiple processes
Hi, I'm using multiple processes for a print: one set of settings for the first couple layers, then that process stops printing and the other process takes over. I have a couple questions though: Do the first layer settings (first layer height, width, etc) apply on the second process (i.e do those s...
- Sat Mar 11, 2017 8:50 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Problems getting settings right after switching nozzle sizes
- Replies: 1
- Views: 981
- Jump to post
Problems getting settings right after switching nozzle sizes
I swapped from a 0.5mm to 0.4mm nozzle on my Taz 6, and I cannot seem to get my settings dialed in properly in Simplify3D. Lines appear waaay too far apart no matter what I do. Here's what it looks like: http://imgur.com/a/5TvC4 First I (duh) changed the nozzle diameter setting. I adjusted the Z-off...
