Simplify3D User Forum

smeek

Thanks for that. That explains a lot. Guess it is time to reflash my board. Or using the M400 and G4 seems to be working as long as I run it from the SD card.

smeek

M600 does not work either. Thanks

smeek

Thanks for reply, I have been checking RepRap forum for replies to my post but none there so far. http://forums.reprap.org/read.php?406,818355 Here is what I have come up with so far. I have been running test prints with no filament using this in the post process window: {REPLACE "; layer 3,&qu...

smeek

Use M226 ; for resume it waits for a pressure on the display's button. http://reprap.org/wiki/G-code#M226:_Gcode_Initiated_Pause http://reprap.org/wiki/G-code#M226:_Wait_for_pin_state Thanks for your reply. I have already tried M226 and it does not work. I have also read the wiki's. I have saved gc...

smeek

I'm using this code for stop and continue: {REPLACE "; layer 37," "G91 \nG1 Z10 \nG90 \nG1 X0 Y200 \nM0 Click To Restart \nG91 \nG1Z-10 \nG90 \n; layer 37,"} Thanks, I'll give that a try. I know its been a while but I am getting back to this now. This code works except for the p...

smeek

brian442 wrote:Also, you can read about what the post-processing commands do here:
viewtopic.php?f=8&t=1959

Thanks, I have read that. Good info....

smeek

MasterFX wrote:I'm using this code for stop and continue:
Code: Select all
{REPLACE "; layer 37," "G91 \nG1 Z10 \nG90 \nG1 X0 Y200 \nM0 Click To Restart \nG91 \nG1Z-10 \nG90 \n; layer 37,"}

Thanks, I'll give that a try.

smeek

Hello, I found the following code on youtube. It is to allow for changing the filament color at a selected layer. It seems to work for the most part except the first thing it does is raise the Z height by 5 cm and when it comes back to print the Z height does not come back down to the original heigh...

smeek

MasterFX wrote:I'm using Skynet Firmware on my A8 without any problems. Since it is only a slightly modified Marlin Firmware there is no problem.
You don't have to change any parameters in your Profile which you have used with your stock firmware.

Thanks!

smeek

Hello, pretty new to 3D printing but learning. Big fan of S3D so far. Can someone share a post script that would work for an Anet A8 for changing color filament. I found a couple examples but didn't work for me so probably for different firmware. I just want to pause the print after layer 4, move th...

Search found 11 matches

Re: Post Processing Anet A8

Re: Post Processing Anet A8

Re: Post Processing Anet A8

Re: Post Processing Anet A8

Re: Post Processing Anet A8

Re: Post Processing Anet A8

Re: Post Processing Anet A8

Post Processing Anet A8

Re: Skynet Firmware

Re: Sharing: Raise3D Pause Script