Search found 2 matches
- Mon May 22, 2017 5:58 pm
- Forum: Troubleshooting and Bug Reports
- Topic: CTC Bizer Dual just stops
- Replies: 4
- Views: 1524
- Jump to post
Re: CTC Bizer Dual just stops
Printing from an SD card, using a file that came with the printer. I've also tried with a file generated using Simplify3d on my Mac (again, via SD card). Same thing happens - the print starts happily, but just stops after less than a minute, partway through the first layer (but not always at the sam...
- Sun May 21, 2017 9:45 pm
- Forum: Troubleshooting and Bug Reports
- Topic: CTC Bizer Dual just stops
- Replies: 4
- Views: 1524
- Jump to post
CTC Bizer Dual just stops
Hi, I just got a new CTC Bizer Dual, and ran through the setup process no problems at all. But whenever I do a print, whatever the file, it starts off just fine, but then stops after less than a minute (possibly, although I'm not certain, at the end of the first layer). Once it's stopped it just sit...
