Simplify3D User Forum

beemergb

German REpRap Protos V3 , but with updates all over ! Board is Ramps 1.4 and I think your right , its the board as one of the lights on the board thats part of the heating system is not blinking ,meaning Im fried !! Oh well easy fix , after 4 years no problems I must expect some kind of trouble now ...

beemergb

I have just encounterd a large problem , and never had this happen before . I set the hot end to 230 and all was good , then all of a sudden it keeps on going up and up like 360 degrees !! The thermistor shows me what happening , but cant tell me why ! Swapped thermistor just incase , same thing aga...

beemergb

Bed Leveling Wizard does its thing , corner to corner , all fine , paper under the nozzle check all good . Go back to start the print and it goes in to the starting point then it lifts higher and ofcourse wont lay the filament down on the printing table properly as its to high ! Any idea whats happe...

beemergb

Hi 3D people .I have a problem . My printer starts to print , this object is 50mm high , but when it gets to 22mm it stops ! Then starts again and moves sometimes right ,and starts printing again , and stops at 22mm ! And then this time it stops moves forwards and starts all over again ! And youve g...

beemergb

I am having a problem with my Simplify 3D program , when I try to print this part lying down its looks like this ! With parts missing and parts I havent even drawn ! And when I print the part standing up its ok ! Can you help me please , thank you Harry

beemergb

Hi folks , I have a problem when I press the pause button and then try to switch it back onto run the pause stays on and I have tried switching the printer off restarting all to no avail ! Any Ideas what I can do ? Hope you can help , Harry

beemergb

Hallo there , fighting my way to get my TronxyX5S to run ! Have found a lot of my inbuilt faults ,small but deadly . Now I have another problem , I have put in the G codes for TronxyX5S ,330x330x400 enterd it all , and went to X3G and it tells me this is for Makerbot Printer only .Does this mean tha...

beemergb

Hello ,my 3d Printer has just stopped automatic homing on finishing the printing program , it stops dead on the last Point , when it should then return to its home position .Any ideas what is causing this ? Hope you can help .

Search found 8 matches

Re: Overheating BIG TIME !

Overheating BIG TIME !

Bed Leveling Wizard problem

Program stops and then carries on in another position

Errors when printing part

Pause wont switch off

TronxyX5S and Simplify 3D compatibility

Not homing after ending printing