Search found 3 matches
- Sat Jun 03, 2017 6:55 pm
- Forum: Troubleshooting and Bug Reports
- Topic: brim lifting
- Replies: 2
- Views: 2641
- Jump to post
Re: brim lifting
Hi, first, it's totally useless to make a Brim on a Raft ... and your first layer is too high, 2 solutions : -setup presisly your bed level with the Bed level Wizzard -go in prosess and in layer tab, lower the First Layer height (I Set them 70% ) Personally I never print on the glass directly, I use...
- Thu Jun 01, 2017 6:25 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Dual extrusion can't Offset
- Replies: 1
- Views: 1623
- Jump to post
Dual extrusion can't Offset
Hello, I buyed S3D specially for make dual extrusions, but I can't setup the offset .. I have a Zonestar D805 dual (Repetier firmware) after a couple of hours I am totally unable to setup the dual extrusion .... I tried all this things : -Setup the offset in Options , machine , toolhead offset, I tr...
- Thu Jun 01, 2017 12:18 pm
- Forum: General Discussion and Tips
- Topic: Not homing after ending printing
- Replies: 3
- Views: 10392
- Jump to post
Re: Not homing after ending printing
Hello ! One important thing : Think it's a 3D printer !!! NEVER home after a print ! it's dangerous for your printer and printed object Depend of your 3D printer, but in many cases, like mine, if I home when the print are finished, the center bar simply go down on printed piece and explode them ! I ...
