Search found 2 matches
- Mon Sep 04, 2017 1:16 am
- Forum: Troubleshooting and Bug Reports
- Topic: Models float in air after using Variable Settings Wizard
- Replies: 2
- Views: 2369
- Jump to post
Models float in air after using Variable Settings Wizard
I created a file in Rhinoceros 5.0 for a knob. I printed an early version with Variable print settings using S3D ver 4.0. This knob is for the timer on a Toaster oven I use, so there is a lot of spring tension. the knob has a flat round surface that faces the user of the oven, it is 40mm in diameter...
- Fri Jun 30, 2017 5:00 pm
- Forum: General Discussion and Tips
- Topic: Can I change from PLA to ABS mid-print?
- Replies: 1
- Views: 2246
- Jump to post
Can I change from PLA to ABS mid-print?
I have a 3d printer that says it can print with ABS, but the table heat will not go above 75c and I am told it needs to go to 110c. I am making a light switch plate that has raised letters. It always results in warping mid-print and I have to cancel it. I have also used utra-hold hairspray as adhesi...
