Search found 3 matches

Go to advanced search

by JorgD
Wed Sep 11, 2019 9:02 pm
Forum: Feature Requests
Topic: Modifier Mesh
Replies: 14
Views: 6554

Re: Modifier Mesh

I can assure you there is massive interest in this feature. Being able to change infill parameters for parts of a model saves a lot of time and material on huge models on a Creality S5. Why infill the whole model at the densest requirement when only a small part needs dense infil? And sadly this par...
by JorgD
Wed Aug 01, 2018 9:33 pm
Forum: General Discussion and Tips
Topic: Prusa i3 MK3 poor surface above supports
Replies: 4
Views: 2163

Re: Prusa i3 MK3 poor surface above supports

As airscapes mentioned, getting the supports to work well does require some tweaking via trial and error. I use a Prusa i3 MK2s and these are the settings that work best for me. Sometimes I need to set the location of the support manually in S3D so that it does not leave unsupported gaps where suppo...
by JorgD
Mon Aug 28, 2017 4:16 am
Forum: General Discussion and Tips
Topic: Initial G-Code to prepare filament
Replies: 1
Views: 627

Re: Initial G-Code to prepare filament

It is hard to tell if your current mode is absolute or relative, so to be certain of the mode I need I would prefix your extrusion code with: G91 ; Set relative positioning This will make sure your commands are relative to the current position and thus you should get 5mm of extrusion. Another proble...

Go to advanced search