Search found 6 matches

Go to advanced search

by DrBoo
Thu Nov 23, 2017 8:55 am
Forum: Troubleshooting and Bug Reports
Topic: 'process' layer height bug
Replies: 1
Views: 783

'process' layer height bug

I have a video of this bug at http://www.taswegian.com/s3dbug.mp4 Hopefully I can describe it well enough that viewing the video is not necessary. I set up a process with the "Advanced/Stop Printing at Height" setting set to partway up my model. In the example 15.04 mm. The idea is to have two proce...
by DrBoo
Tue Sep 12, 2017 12:35 am
Forum: Troubleshooting and Bug Reports
Topic: Missing Support on rotated objects?
Replies: 4
Views: 1685

Re: Missing Support on rotated objects?

Did you do EXACTLY what I suggested??? You'll save plastic and print time if you do! And you'll reduce the risk of the print falling over whilst printing!!! Yep, I was previously unaware that you could split into individual isolated parts, so this was a great addition to my "toolset". I also unders...
by DrBoo
Fri Sep 08, 2017 3:33 am
Forum: Troubleshooting and Bug Reports
Topic: crash when removing all support fill angles
Replies: 1
Views: 541

crash when removing all support fill angles

I am using Simplify3D 4.0.0 on OSX 10.11.1 I have a reproducible bug that causes Simplify3D to crash and exit. In the profile settings, under Support tab, remove all "support infill angles" such that the window/box at bottom right showing angles is completely empty. Now click OK, and "prepare to pri...
by DrBoo
Tue Sep 05, 2017 6:08 pm
Forum: Troubleshooting and Bug Reports
Topic: Missing Support on rotated objects?
Replies: 4
Views: 1685

Re: Missing Support on rotated objects?

Thanks for the assistance. With lower pillar resolution the issue was fixed.
by DrBoo
Tue Sep 05, 2017 10:00 am
Forum: Troubleshooting and Bug Reports
Topic: Missing Support on rotated objects?
Replies: 4
Views: 1685

Missing Support on rotated objects?

I have an odd situation where support is not generated for an object that has been rotated. I probably don't understand how to do supports properly, but in any case, here's the issue... I'm printing the INMOOV part "coverfinger1". I've rotated it so that it's orientated 90 degrees, giving it a verti...
by DrBoo
Wed Aug 30, 2017 7:30 am
Forum: Troubleshooting and Bug Reports
Topic: Innocuous slicer bug
Replies: 0
Views: 822

Innocuous slicer bug

I have been using S3D for a few years now. I've recently become aware of a slicer 'bug' that does not affect the final result, but does result in some difficulty printing objects. Consider a surface with recessed text. The text, say, about 1mm deep, and not terribly big. Perhaps 1cm letter height (a...

Go to advanced search