Search found 3 matches
- Sat Sep 23, 2017 2:24 pm
- Forum: General Discussion and Tips
- Topic: How accurate do you think S3D cost estimate is?
- Replies: 5
- Views: 3952
- Jump to post
Re: How accurate do you think S3D cost estimate is?
It should be very close. As long as you give it good data. Really cost of the Kg of material. Unlike time estimates, which will vary quite a bit once they hit an individual Printers firmware and hardware, materials estimates should be very precise. How many mm will be extruded? As long as your mater...
- Sat Sep 23, 2017 1:51 pm
- Forum: Troubleshooting and Bug Reports
- Topic: [FIXED] Processes not being saved/loaded for in factory file
- Replies: 6
- Views: 4704
- Jump to post
Re: Processes not being saved/loaded for in factory file.
Same thing here. I suspect part of it may be larger or finer resolution/higher poly models in a 4K viewing space that is exceeding some limitation and causing S3d to go haywire or crash.
- Sat Sep 23, 2017 12:26 am
- Forum: Troubleshooting and Bug Reports
- Topic: Frequent Simplify 3d crash on Process to Print
- Replies: 1
- Views: 1990
- Jump to post
Frequent Simplify 3d crash on Process to Print
Any suggestions would be appreciated. I get frequent incidents of "Simplify 3d has stopped working" or similar when I go to process a moderate or large model to print. Nothing outrageously huge. It also seems to crop up after slicing multiple models in a row. I suspect that it is not likin...
