Search found 4 matches
- Wed Nov 01, 2017 6:12 pm
- Forum: General Discussion and Tips
- Topic: Cannot get support to stick to ABS
- Replies: 1
- Views: 1179
- Jump to post
Cannot get support to stick to ABS
I am using Hartchbox ABS filament 1.75 and have been happy with it. It prints well on my Flashforge Creator pro set at 230 degrees C and build plate at 110 deg C. My model needs support and am using Stratasys support material because it washes off very well and works well on its own. However it refu...
- Mon Oct 30, 2017 4:53 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Segmented curves
- Replies: 2
- Views: 2806
- Jump to post
Segmented curves
Using Flash Forge Creator Pro. In printing a small part with a gentle curved wall it comes out segmented rather than smooth..... like small brick wall. What causes this? Is it a software problem? Can it be fixed in the setups?
- Fri Oct 13, 2017 12:37 pm
- Forum: General Discussion and Tips
- Topic: Export an FFF profile.
- Replies: 0
- Views: 1579
- Jump to post
Export an FFF profile.
Export an FFF profile. What does it do? I see the changes in the G Code but when I want to use these same profiles again and I Import the FFF profile I do not see the saved changes in the process settings. So what does saving the FFF profile do for me? How would I save the profiles for a new print r...
- Wed Sep 20, 2017 4:11 pm
- Forum: Troubleshooting and Bug Reports
- Topic: [SOLVED] Excess material on sharp corners
- Replies: 6
- Views: 7683
- Jump to post
[SOLVED] Excess material on sharp corners
Using Flash forge creator pro and Simplify 4.00. With .4mm extruder and layer height at .2mm all of the small part being printed comes out fine except on some very sharp corners where there is excess material extruded and therefore the final layers show a lump higher at these sharp corners than the ...
