Search found 6 matches

Go to advanced search

by bs32
Sat Apr 06, 2019 10:55 pm
Forum: Troubleshooting and Bug Reports
Topic: Is there a way of changing the final surface pattern
Replies: 2
Views: 361

Re: Is there a way of changing the final surface pattern

Howard, In your FFF settings, change your "External Infil Pattern" to Rectilinear. Then change your "External Infill Angle Offsets to 45° and -45° :D
by bs32
Sat Apr 06, 2019 10:42 pm
Forum: Feature Requests
Topic: Makerbot Replicator+
Replies: 0
Views: 368

Makerbot Replicator+

Please add full support for MakerBot Replicator+. I know that the 5th gen is VERY similar, but it is not the same. I have been hoping that you would add full support since this printer was purchased in 2016. Also, I noticed that after the last software update (4.1.2) circles are now printing oblong....
by bs32
Sat Apr 06, 2019 10:40 pm
Forum: Feature Requests
Topic: SpiderWeb infill
Replies: 0
Views: 327

SpiderWeb infill

I print quite a lot of circular parts. I would like to minimize my infill, but maximize strength. Is it possible to add an infill that "radiates" from the center of a circular cutout/hollow and then also has cross infill on that? Think spiderweb-esque...
by bs32
Sat Feb 10, 2018 10:50 am
Forum: Troubleshooting and Bug Reports
Topic: Makerbot Replicator+ heat sap
Replies: 2
Views: 496

Re: Makerbot Replicator+ heat sap

Sorry it has been so long. Heat sap = a 20degree drop in the extruder. I have been searching for code to input in the gcode for the extruder to report back to the printer more often and have the printer adjust the temp as needed. (I am newer to 3d printing, but I have machining experience with gcode...
by bs32
Fri Jan 12, 2018 10:08 am
Forum: Troubleshooting and Bug Reports
Topic: Makerbot Replicator+ heat sap
Replies: 2
Views: 496

Makerbot Replicator+ heat sap

I have a Makerbot Replicator+. When I try to run a print that was generated with S3D, after about 15 minutes, the print stops and I get a heat sap error. When I print the same print using the makerbot software to generate g-code, There are no heat issues (just crappy prints!). There was a firmware u...
by bs32
Mon Nov 06, 2017 8:04 pm
Forum: General Discussion and Tips
Topic: Sticking filament to the build plate
Replies: 0
Views: 446

Sticking filament to the build plate

So far I have been able to get PLA, ABS, and PETG all to stick to an unheated build plate by using plasti dip coating (I use the dip in a can vs the spray and just use $.30 paint brushes to apply). I was struggling to get prints to stick on this makerbot replicator+ unheated bed (and no good way to ...

Go to advanced search