Search found 6 matches
- Sun Nov 18, 2018 4:31 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Allow Single Extrusion Walls causing Parts of Benchy's anchor hole frame to go missing
- Replies: 1
- Views: 1032
- Jump to post
Allow Single Extrusion Walls causing Parts of Benchy's anchor hole frame to go missing
When I change the External Thin Wall Type to "Allow Single Extrusion Walls", parts of the model go missing. See below: External Thin Wall Type = Allow Single Extrusion Walls: Allow Single Extrusion Walls.png External Thin Wall Type = Perimeters only: Perimeters only.png Factory file: https...
- Mon Dec 04, 2017 12:28 am
- Forum: General Discussion and Tips
- Topic: Weistek printer compatibility
- Replies: 14
- Views: 11091
- Jump to post
Re: Weistek (and GP3D Root) printer compatibility
I've been successfully using my GP3D Root with S3D for a couple of weeks now - with the 'sleep S3D process to allow it to reset' trick wrapped up in a simple double-clickable command file on my Mac.
I've posted my settings and a description of them on GitHub.
I've posted my settings and a description of them on GitHub.
- Thu Nov 16, 2017 10:52 pm
- Forum: General Discussion and Tips
- Topic: Weistek printer compatibility
- Replies: 14
- Views: 11091
- Jump to post
Re: Weistek printer compatibility
That doesn’t work. I think what happens is that S3D blindly tries to start communicating with the ASCII protocol, when the printer actually needs the binary one. If S3D just waited after opening the port before starting to try things (as my force pausing the process for a few seconds emulates), it w...
- Thu Nov 16, 2017 12:35 am
- Forum: General Discussion and Tips
- Topic: Weistek printer compatibility
- Replies: 14
- Views: 11091
- Jump to post
Re: Weistek (and GP3D Root) printer compatibility
So, here’s what’s going wrong with the serial connection: The Root resets itself whenever a Connection is established. It’s then unresponsive to serial input for a few seconds while it reboots. It’s during that unresponsive time that S3D is trying to establish communication - so it ends up thinking ...
- Wed Nov 15, 2017 1:16 am
- Forum: General Discussion and Tips
- Topic: Weistek printer compatibility
- Replies: 14
- Views: 11091
- Jump to post
Re: Weistek printer compatibility
Thank you! Since I last posted, and before you replied, I've created my own start/end GCode based on a mix of examining the GCode output by Germinate, looking at the profile I found at http://hardy-parts.xobor.de/t62f38-Simplify-d-fuer-WT.html - which seems to be the same as yours, and the code from...
- Sun Nov 12, 2017 8:41 pm
- Forum: General Discussion and Tips
- Topic: Weistek printer compatibility
- Replies: 14
- Views: 11091
- Jump to post
Re: Weistek printer compatibility
Did anyone get this to work? I have a GP3D Root (non-plus), which I believe is a rebranded Weistek W150, and I'd very much like to get it to work before the 2 week trial runs out... I'm trying a bunch of things myself, and will post if successful, but it would be great if someone had a profile they ...
