Simplify3D User Forum

wapiti59

Yes, it is in the G code, as you said, so it is not an issue with Simplify 3D. It appears that there is something going on in Octoprint then that is causing it to not execute properly. Since the Servo Trigger is run by Octoprint and not the printers firmware, it must be passing M150 straight to the ...

wapiti59

I've got an issue I'm trying to solve, and need some help. I built and set up a mount for a standard hobby servo to deploy a brush over the print bed, with the intent that when the extruder heats up, it makes a few passes over the brush to clean itself off before starting a print. The challenge I ha...

wapiti59

OK - I have been trying to figure this out for two days now, and am still no where. My 2016 FFCP had Sailfish 7.8 on it when I got it, that apparently had been modified to remove a number of parameters including P-Stop (I installed Filament monitors and needed it). So, based on recommendations, I in...

wapiti59

I'm a new user to this software. It appears like the first layer that's being laid down is burned. I'm printing in Red PLA, and the first layer is REALLY dark, and the outline that it always prints around the print is VERY dark and I have to scrape it off the bed. It comes off in tiny pieces almost ...

Search found 4 matches

Re: embedding M150 commands to execute

embedding M150 commands to execute

Re: Another toolhead offset thread

Burned first layer