Search found 4 matches

Go to advanced search

by wapiti59
Wed Dec 11, 2019 7:23 am
Forum: Troubleshooting and Bug Reports
Topic: embedding M150 commands to execute
Replies: 2
Views: 841

Re: embedding M150 commands to execute

Yes, it is in the G code, as you said, so it is not an issue with Simplify 3D. It appears that there is something going on in Octoprint then that is causing it to not execute properly. Since the Servo Trigger is run by Octoprint and not the printers firmware, it must be passing M150 straight to the ...
by wapiti59
Tue Dec 10, 2019 10:52 pm
Forum: Troubleshooting and Bug Reports
Topic: embedding M150 commands to execute
Replies: 2
Views: 841

embedding M150 commands to execute

I've got an issue I'm trying to solve, and need some help. I built and set up a mount for a standard hobby servo to deploy a brush over the print bed, with the intent that when the extruder heats up, it makes a few passes over the brush to clean itself off before starting a print. The challenge I ha...
by wapiti59
Tue Mar 13, 2018 3:19 pm
Forum: Troubleshooting and Bug Reports
Topic: Another toolhead offset thread
Replies: 6
Views: 3491

Re: Another toolhead offset thread

OK - I have been trying to figure this out for two days now, and am still no where. My 2016 FFCP had Sailfish 7.8 on it when I got it, that apparently had been modified to remove a number of parameters including P-Stop (I installed Filament monitors and needed it). So, based on recommendations, I in...
by wapiti59
Wed Nov 29, 2017 1:28 pm
Forum: Troubleshooting and Bug Reports
Topic: Burned first layer
Replies: 1
Views: 992

Burned first layer

I'm a new user to this software. It appears like the first layer that's being laid down is burned. I'm printing in Red PLA, and the first layer is REALLY dark, and the outline that it always prints around the print is VERY dark and I have to scrape it off the bed. It comes off in tiny pieces almost ...

Go to advanced search