Next question: I printed out a 1 inch cube using the high quality settings. When measuring it with a micrometer, it's about .995 on each side depending on whether it's measured at the top or in the middle. Is there a master setting that consistently compensates for the -0.5% scaling error outside of...
It's working! I have it set to high quality, so I'm running a 1 inch cube and a test piece that should interface with a machined part if it's dimensionally correct. So far, the edge quality is much better than with the Qidi software.
OK. The gcode file works. You have the bed temp set way up to 100C, but it works. I was playing with the factory file for a few minutes at lunch and I guess I don't know what I'm doing. A local buddy can help me, though. I was trying to change from ABS to PLA at the upper left and set a left extrude...
Same story as before. It does everything except extruded filament onto the platform (at 190 degrees). There is a VERY thin smearing of filament, but it isn't really extending. I tried a gcode file from the Qidi software and it worked without problems at 190 degrees.
Wow! Thank you so much for replying to my post. I was hoping that would happen. I have the settings loaded and have a test gcode file all set to run after my current print is done. I still don't understand why you have the PLA extruder temps set so high. I turned them down to what I know works (190C...