Simplify3D User Forum

ikaplinsky

+1 I endorse the idea of the Ironing feature. I have read about the trick with additional process on top, but we need to polish top layers on different heights (areas), so using additional-process-trick would be quite consuming for setting up. Developing this idea I think about ironing the first lay...

ikaplinsky

Hi Chris, Rumba board is good, from my point the benefit of this board that it has 6 stepper drivers onboard and you could use Diamond extruder with no additional hardware upgrade (like stepper driver expansion board) Say, are you using Marlin or Repetier firmware ? According to information from thi...

ikaplinsky

Hm, it is interesting, I also noticed that S3D generate a lot of lines. I don't know for sure, my hypothesis that it related with STL detailing (resolution) - probably other slicers can simplify a model or interpolate or group lines for simplification.. (again - I don't know for sure) Just for check...

ikaplinsky

From photos you have attached I consider that it is not a top layer problem, it looks like Blobs.
In this case learn "Blobs and Zits" section, there are good recommendations to suppress such artefacts
https://www.simplify3d.com/support/prin ... s-and-zits

ikaplinsky

Hi Kill K! I also have Delta machine and also faced such blobs issue I have some question to you: What kind of extruder drive do you use: bowden, right ? What is the teflon tube length? (would like to compare with mine) What type of material do you use (plastic) ? Have you seen S3D Print Quality Tro...

Search found 5 matches

Re: Ironing

Re: Stuttering causing tiny blobs on parts

Re: Stuttering causing tiny blobs on parts

Re: Help with lines on top layer

Re: Stuttering causing tiny blobs on parts