Search found 3 matches
- Wed Jan 10, 2018 9:57 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Stuttering causing tiny blobs on parts
- Replies: 5
- Views: 3875
- Jump to post
Re: Stuttering causing tiny blobs on parts
Ill have to try to lower the amount of polys on the STL and see what happens. Im not sure that this will help but its worth a shot. I also think that it is a shame that it wont output G02/G03 code as this would reduce the amount of points and allow for smoother movements. The problem with this line ...
- Tue Jan 09, 2018 2:02 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Stuttering causing tiny blobs on parts
- Replies: 5
- Views: 3875
- Jump to post
Re: Stuttering causing tiny blobs on parts
Igor, The extruder type is a Bowden and the Teflon tube is approximately 350 mm long. I am using AIO PLA (that I have had good results with before). I have seen the Troubleshooting guide and found no answer to my issue. The blobs are not happening at the beginning or end of the layer but throughout....
- Sun Jan 07, 2018 11:32 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Stuttering causing tiny blobs on parts
- Replies: 5
- Views: 3875
- Jump to post
Stuttering causing tiny blobs on parts
I just started using S3D about 2 weeks ago and I have a Kossel Mini that is running a Rumba board with DVR 8825's. The drivers are properly tuned and I have had great prints before running slicers other than S3D. I am seeing vary tiny blobs on the outside of my parts since i started slicing with S3D...
