Thanks for the reply. I just noticed it. (Not receiving notifications for some reason)
I will take a look at your suggestion re. the supports. Thank you.
Search found 6 matches
- Wed Feb 07, 2018 11:06 am
- Forum: General Discussion and Tips
- Topic: Dense Support Questions
- Replies: 2
- Views: 2381
- Jump to post
- Wed Feb 07, 2018 11:03 am
- Forum: Feature Requests
- Topic: Raft Above Supports
- Replies: 4
- Views: 2667
- Jump to post
Re: Raft Above Supports
If I add dense supports @ 100%, isn't that essentially bonding the support to the print?
- Sun Jan 28, 2018 11:04 am
- Forum: Feature Requests
- Topic: Raft Above Supports
- Replies: 4
- Views: 2667
- Jump to post
Raft Above Supports
I would like to be able to have S3D build a raft on top of supports to improve the underside surface quality of the supported part of the print.
Or.. if there is a way to do this manually now I would appreciate knowing how to do it.
Or.. if there is a way to do this manually now I would appreciate knowing how to do it.
- Fri Jan 26, 2018 5:21 pm
- Forum: Troubleshooting and Bug Reports
- Topic: support print quality help
- Replies: 2
- Views: 2108
- Jump to post
Re: support print quality help
Were you able to improve this at all? I have a similar issue and have been trying the advice in the S3D guide, but that first layer doesn't seem to change no matter what I do. It is just not good at all.
- Thu Jan 25, 2018 11:36 am
- Forum: General Discussion and Tips
- Topic: Dense Support Questions
- Replies: 2
- Views: 2381
- Jump to post
Dense Support Questions
I'm new to S3D and have been reading a lot about support structures. But I still have some questions. 1) Is it possible to specify Dense Support Layers per individual supports? Or must that setting apply to the entire print? 2) If I specify 3 Dense Support Layers, S3D prints these both on the top AN...
- Sun Jan 14, 2018 7:46 pm
- Forum: General Discussion and Tips
- Topic: Print Quality Issue Where Supports Were Attached
- Replies: 1
- Views: 951
- Jump to post
Print Quality Issue Where Supports Were Attached
My first print with S3D came out rather well, except for where supports were attached. I used default settings since I am brand new to S3D. I have attached a photo. The one on the bottom is my prototype. The one on the top is my print. It's as if the surface layer was not even printed(?) I left some...
