Search found 3 matches
- Sun Oct 14, 2018 12:21 pm
- Forum: Feature Requests
- Topic: Skirt Speed
- Replies: 13
- Views: 12753
- Jump to post
Re: Skirt Speed
I too ran into this problem. Skirt was printing too fast and was not adhering properly. Yes, "First layer underspeed" does apply to the skirt, but in the end skirt is still printing faster than everything, because model is subject to two other speed reductions, "outline underspeed&quo...
- Fri Feb 23, 2018 9:23 am
- Forum: Troubleshooting and Bug Reports
- Topic: Support of the angled surface problem
- Replies: 2
- Views: 1135
- Jump to post
Re: Support of the angled surface problem
After I posted it I found a combination of parameters that produced a reasonable support structure. Still, the software should not generate garbage, even if it can't produce something working with the parameters given. I noticed that horizontal offset from the part can't be used unless you have only...
- Wed Feb 21, 2018 11:17 am
- Forum: Troubleshooting and Bug Reports
- Topic: Support of the angled surface problem
- Replies: 2
- Views: 1135
- Jump to post
Support of the angled surface problem
I'm relatively new to S3d and I'm having trouble with supports generated for the angled surface (61 deg from vertical) support problem.png First of all, as you can see, S3D generates small segments of support completely detached from anything, both from the model and from support. As expected, it pr...
