Search found 7 matches
- Sat Mar 10, 2018 9:02 am
- Forum: Troubleshooting and Bug Reports
- Topic: S3D creates a stringy print
- Replies: 8
- Views: 3379
- Jump to post
Re: S3D creates a stringy print
Thanks it was indeed the zhop which cause my issue. I was under the impression that you first have the retraction followed by the hop. In that case there would not be much filament in the nozzle. But in fact it’s first pulled out of the nozzle by the zhop and then retracted. Thanks since I didn’t go...
- Tue Mar 06, 2018 3:38 am
- Forum: Troubleshooting and Bug Reports
- Topic: S3D creates a stringy print
- Replies: 8
- Views: 3379
- Jump to post
Re: S3D creates a stringy print
I pulled up your GCODE for a quick peek. 1mm Z-lift on retraction? That's going to be a string generator right there. Don't lift any more than absolutely necessary. I normally run zero because it minimizes stringing, but the rest of your build needs to be spot on for that. If you're extrusion multi...
- Mon Mar 05, 2018 3:00 pm
- Forum: Troubleshooting and Bug Reports
- Topic: S3D creates a stringy print
- Replies: 8
- Views: 3379
- Jump to post
Re: S3D creates a stringy print
I really doubt accel and jerk are the cause of your stringing. without knowing anything about the part, material, settings, etc ... it's hard to guess at what you might be facing. I'm not in to reading your GCODE to see what you're doing. Thanks I was planning on uploading all the screen captures t...
- Sun Mar 04, 2018 3:15 pm
- Forum: Troubleshooting and Bug Reports
- Topic: S3D creates a stringy print
- Replies: 8
- Views: 3379
- Jump to post
Re: S3D creates a stringy print
You can add information in the scripts tab to control acceleration and jerk. Here are the lines in my start script. I have a different printer, so these values won't be optimal for yours. Accel gcode for startup script M201 X1600 Y1600 E5000 ; acceleration M205 X12 Z1.0 E5000 ; jerk M204 T7200 ; tr...
- Sun Mar 04, 2018 8:24 am
- Forum: Troubleshooting and Bug Reports
- Topic: S3D creates a stringy print
- Replies: 8
- Views: 3379
- Jump to post
Re: S3D creates a stringy print
Sorry, I missed the S3D gcode.
- Sat Mar 03, 2018 6:56 pm
- Forum: Troubleshooting and Bug Reports
- Topic: First layer help?
- Replies: 6
- Views: 2860
- Jump to post
Re: First layer help?
Hi, forst of I'm a starter in the 3d printing world but perhaps my settings help you out.
First layer settings:
120% layer height
120% layer width
50% speed
.2 layer height
60mm/s speed
Good luck
First layer settings:
120% layer height
120% layer width
50% speed
.2 layer height
60mm/s speed
Good luck
- Sat Mar 03, 2018 6:51 pm
- Forum: Troubleshooting and Bug Reports
- Topic: S3D creates a stringy print
- Replies: 8
- Views: 3379
- Jump to post
S3D creates a stringy print
Hi all, I recently got a CR-10S and I love the machine. Ease of install en print quality is great. I just have 1 problem and that is stringing / hair on my prints when slicing with S3D, in Cura I don't have the issue at all. All settings are the same, retraction is "reduced" to 2mm due to ...
