Search found 2 matches
- Wed Apr 04, 2018 5:19 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Must disconnect and reconnect -S3D 2.2.2 - Replicator 2 HBP
- Replies: 9
- Views: 9668
- Jump to post
Re: Must disconnect and reconnect -S3D 2.2.2 - Replicator 2 HBP
I am a new user to S3D after using all the other software and slicers over the past 5 years. I just had an "oh s#!t" realization when the heaters didn't turn off after hitting the stop. This could have been dangerous as I was about to leave the house for a quick errand and they would have ...
- Wed Apr 04, 2018 1:17 pm
- Forum: Troubleshooting and Bug Reports
- Topic: [FIXED] Ooze shield and prime pillar
- Replies: 3
- Views: 10800
- Jump to post
Re: Ooze shield and prime pillar
I am having the same issue as DDDSam.
Most of the time it will not not use the prime pillar. When it finally does use it the layer it should be sticking does not exist and creates more ooz/stings. Incredibly frustrating since this is the whole reason I purchased this software.
Most of the time it will not not use the prime pillar. When it finally does use it the layer it should be sticking does not exist and creates more ooz/stings. Incredibly frustrating since this is the whole reason I purchased this software.
