Search found 4 matches
- Mon Mar 13, 2023 2:48 am
- Forum: Troubleshooting and Bug Reports
- Topic: How to print non enclosed model
- Replies: 6
- Views: 7912
- Jump to post
Re: How to print non enclosed model
Hi Dr.D, sorry for the late reply mate, been busier than a mosquito in a nudist camp. Anyhow I decided that I would create an inner wall with a specific gap and dismantle all surfaces manually and rebuild them so as not to cause any internal interferences. It's been a bit of task but I think I'm get...
- Wed Mar 08, 2023 2:16 am
- Forum: Troubleshooting and Bug Reports
- Topic: How to print non enclosed model
- Replies: 6
- Views: 7912
- Jump to post
Re: How to print non enclosed model
Dr.D, thank you for taking the time to answer my plea for assistance, most appreciated. Your suspicion re Non-manifold slicing was correct. Unfortunately after changing to your suggested settings and tweaking some more eg Slicing region mode > Merge all Boundaries, the sliced image looked OK (horizo...
- Mon Mar 06, 2023 10:59 pm
- Forum: Troubleshooting and Bug Reports
- Topic: How to print non enclosed model
- Replies: 6
- Views: 7912
- Jump to post
How to print non enclosed model
Firstly allow me to apologize if this is the incorrect area to place this message. I have been trying to find a way to print a model with a very thin wall thickness eg 1-2mm. I use Rhino for all modeling needs which has an option ( Offset Surfaces) to produce objects with a specified wall thickness ...
- Wed Jul 18, 2018 1:26 am
- Forum: Troubleshooting and Bug Reports
- Topic: S3D not exporting cooling fan command
- Replies: 11
- Views: 9259
- Jump to post
Re: S3D not exporting cooling fan command
I know this is a reasonably old discussion, but I assume the fan itself was checked to confirm it was OK. On 2 occasions now I have had the same situation of the cooling fan not responding and yes I know it was stated earlier that the fan can be manually operated (strange), nevertheless after spendi...
