Search found 3 matches
- Sun Jun 10, 2018 2:36 pm
- Forum: General Discussion and Tips
- Topic: Noob Question about Object Alignment
- Replies: 7
- Views: 5724
- Jump to post
Re: Noob Question about Object Alignment
I’ve been struggling with the same issue. Right now, I’ve been aligning models via S3D, but it seems that a long term solution is to figure out how to set Fusion so the coordinate systems are consistent between models.
- Sun Jun 10, 2018 2:33 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Configuration for Flashforge Inventor
- Replies: 2
- Views: 1860
- Jump to post
Re: Configuration for Flashforge Inventor
Thanks, you are correct. I was assuming that there was consistency within the realm of F.F...
:/
:/
- Mon Jun 04, 2018 11:02 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Configuration for Flashforge Inventor
- Replies: 2
- Views: 1860
- Jump to post
Configuration for Flashforge Inventor
Howdy I'm trying to configure S3D for the Inventor. It seems pretty painless, i.e. specify Flashforge Inventor as the type of printer, which is installed during setup. Make sure that .x3g is enabled under script. Export to SD, which is the same SD that came with the printer, from which the Inventor ...
