Search found 5 matches
- Wed Jun 21, 2023 10:06 am
- Forum: Feature Requests
- Topic: [ADDED] Option to distribute heat more evenly
- Replies: 2
- Views: 1818
- Jump to post
Re: Option to distribute heat more evenly
In order to decide if I should upgrade to v5 (or leave Simplify3D for good): has my suggestion for improvement been understood (or better: implemented) in the meantime already?
- Fri Jul 27, 2018 8:24 am
- Forum: Feature Requests
- Topic: [ADDED] Option to distribute heat more evenly
- Replies: 2
- Views: 1818
- Jump to post
[ADDED] Option to distribute heat more evenly
There's a common problem of local overheating when printing small parts with several "islands" (unconnected sub-parts): with the usual print strategy of printing all perimeter(s) & infill for one particular island first, then proceeding to the next , etc., the nozzle (and heatblock too...
- Mon Jul 23, 2018 4:40 pm
- Forum: Troubleshooting and Bug Reports
- Topic: [FIXED]Perimeters Print Logic Is Wrong
- Replies: 12
- Views: 10862
- Jump to post
Re: Perimeters Print Logic Is Wrong
Well thanks for the info... I found out in the meantime that the "islands sequentially" in fact doesn't do what I imagined, that is to print the perimeters (better still: outlines) of all islands first, then the remaining perimeters (if any) of all islands, and finally the infill of all is...
- Mon Jul 23, 2018 10:16 am
- Forum: Troubleshooting and Bug Reports
- Topic: [FIXED]Perimeters Print Logic Is Wrong
- Replies: 12
- Views: 10862
- Jump to post
Re: Perimeters Print Logic Is Wrong
Ok, answering my own question 
... I bought & installed Simplify3D and found that I could select this strategy with the "Print islands sequentially without optimization" option - nice!
... I bought & installed Simplify3D and found that I could select this strategy with the "Print islands sequentially without optimization" option - nice!- Fri Jul 20, 2018 4:00 pm
- Forum: Troubleshooting and Bug Reports
- Topic: [FIXED]Perimeters Print Logic Is Wrong
- Replies: 12
- Views: 10862
- Jump to post
Perimeters Print Logic Is Wrong
Quick (pre-sales ) question: is this behavior (printing the perimeters for all features before printing the infill for all features) still active in the current version of Simplify3D?
) question: is this behavior (printing the perimeters for all features before printing the infill for all features) still active in the current version of Simplify3D?