Search found 4 matches
- Mon Aug 20, 2018 1:31 pm
- Forum: General Discussion and Tips
- Topic: Perimeter bumps only on curves
- Replies: 10
- Views: 5735
- Jump to post
Re: Perimeter bumps only on curves
It was because of printing over USB. Same setting done via SD card and print came out beautifully. Where is the line drawn as to whether to print over USB vs SD? I prefer USB, due to the ease of being able to VPN at night, from home, and having the part ready the next morning. I can't see it being f...
- Wed Aug 15, 2018 9:20 pm
- Forum: General Discussion and Tips
- Topic: Perimeter bumps only on curves
- Replies: 10
- Views: 5735
- Jump to post
Re: Perimeter bumps only on curves
I've been in the field, the passed couple days, but thanks for the replies. I've definitely read through all the "tips & tricks". Very helpful and did solve many issues over my course of learning. Definitely not moisture. The printer is in a closet under the stairs and stays above the ...
- Mon Aug 13, 2018 3:07 pm
- Forum: General Discussion and Tips
- Topic: Perimeter bumps only on curves
- Replies: 10
- Views: 5735
- Jump to post
Re: Perimeter bumps only on curves
Yet to receive a reply, not too sure if this means no one has a clue. But, I figure I'll share some more info. I was watching the machine print and noticed it stopping, for a fraction of a second, during the curves and it seemed to be still extruding. Even though I knew all was ok with the model, I ...
- Tue Aug 07, 2018 11:14 am
- Forum: General Discussion and Tips
- Topic: Perimeter bumps only on curves
- Replies: 10
- Views: 5735
- Jump to post
Perimeter bumps only on curves
Hello. I'm having issues w/ my MakerGear M2 using MH 1.75 Pro-ABS. I'm getting zits/blobs, but only on curved surfaces. Every other facet of the print is coming out great, straight sections, rafts, supports, etc, all good. I've done close to 3 dozen prints (only doing a small section which contains ...
