Search found 2 matches

Go to advanced search

by hulaomr
Wed Aug 29, 2018 7:25 pm
Forum: General Discussion and Tips
Topic: Layer Shifting
Replies: 4
Views: 763

Re: Layer Shifting

@Ayres3D, @dkightley, @smoki3, thanks all for your feedback and suggestions. Appreciated. I didn't check the speed and other parameter in the printer because I'm using stock parameters from some time ago. I hope those are already ok. Definitely, I will check the firmware is up to date. For now, two ...
by hulaomr
Wed Aug 08, 2018 7:21 pm
Forum: General Discussion and Tips
Topic: Layer Shifting
Replies: 4
Views: 763

Layer Shifting

Hello, It's the first time I see the situation below. https://thumb.ibb.co/kCWtvp/priting_error.png This part was print in fast mode (0.3mm layer) with 100% fill in ABS, using a lulzbot taz 6. The printer is very new. Around 2 plastic roll were used. The software is printing over USB. Any idea is ap...

Go to advanced search