Search found 3 matches
- Sun Aug 26, 2018 12:36 am
- Forum: Feature Requests
- Topic: Cooling fan overrides
- Replies: 3
- Views: 2005
- Jump to post
Re: Cooling fan overrides
Point 1 isn't intended to cool the hot end obviously, its to cool the plastic that seeps out of it, making it easier to break with movement, in theory, will result in far less stringing. Or at least far easier to clean up stringing. While your idea for point 2 is a decent idea, it just doesn't work,...
- Fri Aug 24, 2018 8:30 pm
- Forum: Feature Requests
- Topic: Cooling fan overrides
- Replies: 3
- Views: 2005
- Jump to post
Re: Cooling fan overrides
It would be nice if you could play around in the cooling section of your process to get these results, but if you could, I wouldn't be suggesting it as a feature Another issue is sure, you can tell it to do that with post-processing, but you can't tell it to go back to normal via post processing. No...
- Thu Aug 09, 2018 11:21 pm
- Forum: Feature Requests
- Topic: Cooling fan overrides
- Replies: 3
- Views: 2005
- Jump to post
Cooling fan overrides
Couple of suggestions for cooling fan overrides 1. Fan speed when not extruding Use Case: When printing with filament that doesn't quite like cooling, (eg. PETG) increase fan speed when traveling to reduce stringing 1. Fan speed for outer layer Use Case: Again, for materials that work best with low ...
