Search found 4 matches
- Mon Aug 27, 2018 3:09 pm
- Forum: Troubleshooting and Bug Reports
- Topic: [SOLVED]Weird misalignment issue
- Replies: 6
- Views: 3643
- Jump to post
Re: Weird misalignment issue
Just in case somebody has the same problem, it seems that the problem was a loose synchronous wheel that was holding the Y motor and the axis. I tighted it with an allen wrench and everything was ok! Have to point out that the support team of Colido/Print-rite were very helpful and we went back and ...
- Sun Aug 26, 2018 7:45 am
- Forum: Troubleshooting and Bug Reports
- Topic: [SOLVED]Weird misalignment issue
- Replies: 6
- Views: 3643
- Jump to post
Re: Weird misalignment issue
Well, the extruder was not consistent (thanks a lot!), I did the atomic calibration thing, and the extruder works perfect, and no oozing. The bed is levelled, the pla sticks on the plate and the extruder is calibrated, but unfortunately the y axis consistent inconsistency remain.. :( I have contacte...
- Sat Aug 18, 2018 9:09 am
- Forum: Troubleshooting and Bug Reports
- Topic: [SOLVED]Weird misalignment issue
- Replies: 6
- Views: 3643
- Jump to post
Re: Weird misalignment issue
I have checked the bed, it is Ok, and the pla sticks to it ok. Also, the belts seemed ok, I have re-tensioned them just to be sure but the issue remains. The weird thing is that I have tried printing a box in different places on the bed, and every time I have the same problem, as if the problem is h...
- Fri Aug 17, 2018 6:27 am
- Forum: Troubleshooting and Bug Reports
- Topic: [SOLVED]Weird misalignment issue
- Replies: 6
- Views: 3643
- Jump to post
[SOLVED]Weird misalignment issue
Hello! I am new in 3d printing and I have the Colido 2.0+ 3d printer. I have printed a couple of stuff with simplify3d, but for some reason after some days, the prints show as in the picture. It seems a if it overlaps at the y axis some cm, whereas it prints at the x axis. The weird thing is that is...
