Simplify3D User Forum

imrija

Hi, thanks for your reply! My extrusion multiplier is 1, and I enter the average filament width in slicer everytime I replace the spool. I measure it using calipers. I use quality spools which tend to be +-0.01mm. I'm also doing the linear advance calibration when I get new color from new filament s...

imrija

Thanks for your reply. I'm already printing at 35mm/s and slowing down does not help. The orange first layer is on 50% speed, which means less than 20mm/s. I've tried all the coasting and wiping settings. I've changed everything I thought that might have effect and done 20+ test prints. Also as I sa...

imrija

Hello, I'm having a bit of problems with extrusion on end of the line. Especially on infill, but I also sometimes have gaps on seams on perimeters. DSC_3389.JPG DSC_3396.JPG DSC_3397.JPG All layers are affected. I've tried tuning the linear advance, tried different firmwares (klipper, prusa marlin),...

imrija

Thanks, I've made them to disappear on 60% overlap.
But does not make this the perimeters to bulge on the other sides ?

imrija

Hello, I'm new both here and to s3d. I'm having a little bit of trouble getting my first layer sliced properly. I have gaps between the perimeters and infill. 2018-08-19-233023_821x473_scrot.png What am I doing wrong? The gaps are not present when I use 45° infill, but I need these lines to be horiz...

Search found 5 matches

Re: underextrusion at line end

Re: underextrusion at line end

underextrusion at line end

Re: First layer infill gaps

First layer infill gaps