Search found 5 matches

Go to advanced search

by dinsmoorc
Tue Oct 23, 2018 3:47 pm
Forum: Feature Requests
Topic: More efficient use of Factory File and Source STL file
Replies: 5
Views: 1106

More efficient use of Factory File and Source STL file

I put a post in the general discussion section about whether a factory file needed to have an updated STL file loaded every time a revision was made to the STL. The answers suggested that you do need to remove and re-insert each new version of an STL file. This seems like a lot of un-necessary work ...
by dinsmoorc
Tue Oct 23, 2018 3:41 pm
Forum: General Discussion and Tips
Topic: Do I need to reload STL files after changes
Replies: 6
Views: 668

Re: Do I need to reload STL files after changes

Thanks to both who posted. I guess I was doing it right all along. I would think it better if it could be linked to a STL file. Maybe I will suggest this as a feature. It can be a pain re-creating a factory file with a new design every time. That's what drove me to make this post as it seems like it...
by dinsmoorc
Wed Oct 17, 2018 12:40 pm
Forum: Troubleshooting and Bug Reports
Topic: TMC Error on Prusa I3 MK3
Replies: 0
Views: 300

TMC Error on Prusa I3 MK3

I was getting a TMC error on my Prusa I3 MK3 on a particular part and it was related to a problem with their Einsy board. I got a free replacement from them, stellar support, and installed last night. I upgraded to the latest 3.4.1 Firmware and ran through calibration wizard like it was new. Calibra...
by dinsmoorc
Wed Oct 17, 2018 12:18 pm
Forum: General Discussion and Tips
Topic: Do I need to reload STL files after changes
Replies: 6
Views: 668

Do I need to reload STL files after changes

I've been removing and reinserting STL files every time I change a part I'm designing. Generally I save and replace the STL file when I've made modifications. Is it necessary for me to remove and insert or will the factory file open the latest file as long as its in the same place and filename? I su...
by dinsmoorc
Tue Oct 16, 2018 7:43 am
Forum: Feature Requests
Topic: Prusa Multi Material V2
Replies: 1
Views: 444

Prusa Multi Material V2

Someone may have already posted this but if not here goes... Built in support (beyond scripts and work around) for the use of the new version of Prusa Multi Material version 2. To users and Simplify 3d supports credit there are some scripts and work around approaches to extend the multi-extruder cap...

Go to advanced search