Search found 3 matches
- Wed Jan 04, 2023 10:42 pm
- Forum: General Discussion and Tips
- Topic: Smooth Bottom - Small Part (IMAGE UPDATED)
- Replies: 3
- Views: 3467
- Jump to post
Re: Smooth Bottom - Small Part (IMAGE UPDATED)
Any thoughts on this?
- Sat Dec 17, 2022 5:40 pm
- Forum: General Discussion and Tips
- Topic: Smooth Bottom - Small Part (IMAGE UPDATED)
- Replies: 3
- Views: 3467
- Jump to post
Smooth Bottom - Small Part (IMAGE UPDATED)
I am trying to print a very small part (about 1.5 cm tall x .75 cm wide). See attached. I assume I have the extruder settings fouled up as I cannot get a nice flat/smooth bottom. Instead I can easily see the lines of filament running inside the walls. Any thoughts on how to spread the filament out s...
- Sun Oct 21, 2018 6:35 pm
- Forum: General Discussion and Tips
- Topic: No Support Magical Setting?
- Replies: 4
- Views: 3676
- Jump to post
No Support Magical Setting?
I am trying to print some very small parts. Each part is printed on a small 4mm pin. The round base should be square, but it is not printing correctly since (I can only assume) it needs support. However, these are so small, I don't want/can't get support added. Notice the artifacts hanging below the...
