Search found 2 matches
- Wed May 15, 2019 1:46 pm
- Forum: General Discussion and Tips
- Topic: Printing in a loop?
- Replies: 9
- Views: 9869
- Jump to post
Re: Printing in a loop?
It is doable. I used PLA, on a glass bed. Once the print was done, it would pop the print off the glass, then start over again. All I did was add a few lines of gcode at the end of the file. The file would move the print head to the back of the printer, then move toward the front at a slow speed, th...
- Sun Nov 25, 2018 1:26 pm
- Forum: Troubleshooting and Bug Reports
- Topic: [FIXED] Perimeter issue 4.1.0
- Replies: 2
- Views: 1711
- Jump to post
[FIXED] Perimeter issue 4.1.0
Hello everyone,
I found an issue with v4.1.0 that is not there on v4.0.0.... Using the same factory file, v4.1.0 is missing perimeters, while v4.0.0 is not. Included are pictures of both v4.1.0 and v4.0.0 at the same height. I also am including the factory file.
I found an issue with v4.1.0 that is not there on v4.0.0.... Using the same factory file, v4.1.0 is missing perimeters, while v4.0.0 is not. Included are pictures of both v4.1.0 and v4.0.0 at the same height. I also am including the factory file.
