Search found 3 matches

Go to advanced search

by JNEWMAN
Sun Dec 02, 2018 10:59 am
Forum: Troubleshooting and Bug Reports
Topic: Newbie Issues with Autodesk Inventor STL to print on Flashforge Creator Pro
Replies: 7
Views: 1200

Re: Newbie Issues with Autodesk Inventor STL to print on Flashforge Creator Pro

No I did not use the export options, too complicated. I am merely getting up to speed with it, really helps having this community.

Thanks
by JNEWMAN
Fri Nov 30, 2018 2:22 pm
Forum: Troubleshooting and Bug Reports
Topic: Newbie Issues with Autodesk Inventor STL to print on Flashforge Creator Pro
Replies: 7
Views: 1200

Re: Newbie Issues with Autodesk Inventor STL to print on Flashforge Creator Pro

I worked it out, its how I saved it as an STL. There are 2 ways on inventor to save an .ipt as a .stl The first method is to select export > export as > save an STL this method caused this inches issue. The 2nd way is to save as 3D printer service this then creates a parameters box showing the dimen...
by JNEWMAN
Thu Nov 29, 2018 9:21 pm
Forum: Troubleshooting and Bug Reports
Topic: Newbie Issues with Autodesk Inventor STL to print on Flashforge Creator Pro
Replies: 7
Views: 1200

Newbie Issues with Autodesk Inventor STL to print on Flashforge Creator Pro

Good Morning All. I picked up my printer a Flashforge creator pro, only yesterday, and I am playing around with it made a few prints so far. I am now looking to print my own designs. However I am struggling somewhat. The designs that I produced were done so on Autodesk Inventor, and saved as an .ipt...

Go to advanced search