Search found 5 matches

Go to advanced search

by vandel212
Mon Jan 21, 2019 1:37 pm
Forum: Troubleshooting and Bug Reports
Topic: How to raise first layer without increasing layer height?
Replies: 3
Views: 2442
 
Jump to post

Re: How to raise first layer without increasing layer height?

That might work, I'll have to give it a shot. I was sort of hoping for something a bit more automated like a setting or a additional script for post processing though haha.
by vandel212
Mon Jan 21, 2019 11:41 am
Forum: Troubleshooting and Bug Reports
Topic: How to raise first layer without increasing layer height?
Replies: 3
Views: 2442
 
Jump to post

How to raise first layer without increasing layer height?

Hi, I was looking for a solution to increase the height of the first layer, because when my printer goes to print, it'll print about 3 or 4 layers before actually laying something down. I thought I found the solution in the process setting page with the "First layer height" setting, but I ...
by vandel212
Sun Jan 13, 2019 4:47 pm
Forum: Troubleshooting and Bug Reports
Topic: Z-Axes out of sync
Replies: 3
Views: 1411
 
Jump to post

Re: Z-Axes out of sync

Does anyone have any thoughts on this? This issue basically makes it impossible for me to print anything, and I'm all out of ideas.
by vandel212
Fri Jan 11, 2019 11:36 am
Forum: Troubleshooting and Bug Reports
Topic: Z-Axes out of sync
Replies: 3
Views: 1411
 
Jump to post

Re: Z-Axes out of sync

S3D-Jake wrote: Please attach your G-Code that is working, and then one from Simplify3D that is showing the issue when you try to run it.

Sure thing, here you go. Thanks!
by vandel212
Thu Jan 10, 2019 10:28 pm
Forum: Troubleshooting and Bug Reports
Topic: Z-Axes out of sync
Replies: 3
Views: 1411
 
Jump to post

Z-Axes out of sync

Hi, I have a Robo 3D R1+, and I'm using the default S3D profile for it. When I finish a print, I notice that my X Gantry is way out of level. The right side is visibly higher than the left side. So much so that it wont even auto-level on the next print. What that tells me is during the print, the Ri...

Go to advanced search