Simplify3D User Forum

simplifyba

Fwiw, I discovered that it wasn't travel that I was encountering but rather a laying down of infill at multiple degrees which (as the text warns) was rolling over the same paths a few times each layer. I'd still like to be able to toggle on and off the different feature types though. =)

simplifyba

YES PLEASE! There are a bunch of times where I would have liked to be able to toggle them like in Cura. I am struggling with a travel path right now that is going over the same area again and again and building up a little mountain of goo in the middle of my piece. It would be wonderful if I could t...

simplifyba

Hi Team, I am seeing an issue with the height of the head whenever I start a second print on a Lulzbot TAZ 6. The TAZ is running FW 1.1.9.28. I'm on a Mac running 10.12.6 and my S3D is 4.1.1. After a successful print, the second print can be started, but will always fail because the extruder will to...

simplifyba

You have probably already sorted this out but the offset is normally a negative number, so in your case the offset is probably going to be -1.21.

simplifyba

Hi All, Cura has a feature which allows me to keep the bed heated after a print is finished. I can't launch it to check right at this moment but I thin iIt is just a checkbox called 'Keep Heating' Does S3D have this option somewhere and I just haven't found it or would I have to edit gcode to add th...

simplifyba

I am here as a brand new user to say that I fully expected to do an interwebs search and find a library of S3D filament profiles like the ones that come in Cura by default. T-Glase, nGen, Taulman Bridge, all that. I will continue to search but in the meantime, here is my +1 for this feature and an O...

Search found 6 matches

Re: Enable/Disable Feature Types in Preview Mode

Re: Enable/Disable Feature Types in Preview Mode

Wipe and auto leveling always too high when starting second print

Re: TAZ 6 Zero offset

Keep bed heated after print?

Re: Material Catalogs