Search found 3 matches

Go to advanced search

by RacOutlaw
Mon Feb 18, 2019 9:19 pm
Forum: Troubleshooting and Bug Reports
Topic: Z OffSet
Replies: 4
Views: 769

Re: Z OffSet

Yes that makes since but i must bow my head in shame as i did not think to put that in my reply.. All this is done above the limit switch.. That is how i can jog it down to the height i need before each print is going into the menu and going to z jog and running it down.. Sorry for not thinking abou...
by RacOutlaw
Fri Feb 15, 2019 7:23 pm
Forum: Troubleshooting and Bug Reports
Topic: Z OffSet
Replies: 4
Views: 769

Re: Z OffSet

Yes that is what is going on but i thought that the z-offset in simplyfi3d was or would be the same thing as the z-offset that you use in the menu of the A20m to set a - offset to compensate for the bed height. That is what it does in the z-offset of the menu atleast.. IE: if i start a print and it ...
by RacOutlaw
Wed Feb 13, 2019 5:47 am
Forum: Troubleshooting and Bug Reports
Topic: Z OffSet
Replies: 4
Views: 769

Z OffSet

Ok this is what i am seeing here.. On the g-code tab if i set my z offset to -0.80 the first layer of the print is right where it should be as far as the first layer thickness and also on the wipe pillar. If i look at the live preview however to see what the unit is doing there the layers are not se...

Go to advanced search