Search found 3 matches
- Mon Feb 18, 2019 9:19 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Z OffSet
- Replies: 4
- Views: 2645
- Jump to post
Re: Z OffSet
Yes that makes since but i must bow my head in shame as i did not think to put that in my reply.. All this is done above the limit switch.. That is how i can jog it down to the height i need before each print is going into the menu and going to z jog and running it down.. Sorry for not thinking abou...
- Fri Feb 15, 2019 7:23 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Z OffSet
- Replies: 4
- Views: 2645
- Jump to post
Re: Z OffSet
Yes that is what is going on but i thought that the z-offset in simplyfi3d was or would be the same thing as the z-offset that you use in the menu of the A20m to set a - offset to compensate for the bed height. That is what it does in the z-offset of the menu atleast.. IE: if i start a print and it ...
- Wed Feb 13, 2019 5:47 am
- Forum: Troubleshooting and Bug Reports
- Topic: Z OffSet
- Replies: 4
- Views: 2645
- Jump to post
Z OffSet
Ok this is what i am seeing here.. On the g-code tab if i set my z offset to -0.80 the first layer of the print is right where it should be as far as the first layer thickness and also on the wipe pillar. If i look at the live preview however to see what the unit is doing there the layers are not se...
