Simplify3D User Forum

Tmarino

Typical bullshit we knew was going to happen. I’ve had my version for over 4 years with absolutely dead silence on this forum board for almost every inquiry. A year ago, after absolutely no support I switched to Cura, (oh did I forget to mention that it’s free and has open support ) and it has been ...

Tmarino

Using gwhite's theory, I increased the infill to 100% and the Outer Perimeters to 5 just to see what the effect would be. As you can see from the screen shot, I have NO open aeas underneath in the knuckle areas and it should fill in OK. As stated, this may be agood area to use the Process function a...

Tmarino

gwhite, exactly right! I'll try adjusting infill and the Perimeter shell to see what happens. The one good thing with S3D, you get what the preview shows and I proved that on the first go round. I guess i could use the Process function and adjust the print parameters for this are of the print assumi...

Tmarino

The top preview is FlashPrint and the bottom is the S3D that was printed just as it shows with gapping holes in the knuckle areas just as shown in the preview. I don't use FlashPrint as the FF Creator Pro cam with S3D so that's all I have ever used. I understand about the transition from curve to le...

Tmarino

Attached are snippets from the output of a model previewed in both S3D and Flashprint. Notice the open holes and uneve fill in the S3D snippet as comared to the FP infill. I have tried everything in S3D and these areas are always a mess. I even ran the model through the latest Cura slicer and the re...

Tmarino

The part printed exactly as shown. Not just a graphical represenation.
Any thoughts?

Tom

Tmarino

I recently posted my first topic less than a week ago, concerning a printing quality issue that I was researching, and now the post has disappeared from the forum altogether. I know it was approved and posted to the board as I was keeping an eye on the results. What's going on Mr. Administrator? TMa...

Tmarino

Attached is the print preview for a small clip modeled in 3D builder. I printed out a test piece yesterday and motived the small discrepancies at the innner and outer edges of the star ring, at 12 o'clock and 6 o'clock. I checked out the model and its 'clean'. Is there something on a print setting I...

Search found 8 matches

Re: Licence V4 to V5

Re: Wierd Holes in Print

Re: Wierd Holes in Print

Re: Wierd Holes in Print

Wierd Holes in Print

Re: Wierd Model Artifacts

Missing Post on Forum

Wierd Model Artifacts