Simplify3D User Forum

kmetiuk

When using Perimeters Only the software will do the best job it can to fit in the specified number of extrusions but if the width of your part is not evenly divisible by your extrusion width then there is no way these will fit perfectly. This is why the Gap Fill and Internal Single Extrusions optio...

kmetiuk

Thank you for the images and Factory File! This over-extrusion is happening because you currently have the Outline Overlap in the Infill tab set to 80%. This means that the infill will overlap 80% of the perimeter and this can definitely cause over-extrusion if your printer is well calibrated. Most...

kmetiuk

Thank you for the images and Factory File! This over-extrusion is happening because you currently have the Outline Overlap in the Infill tab set to 80%. This means that the infill will overlap 80% of the perimeter and this can definitely cause over-extrusion if your printer is well calibrated. Most...

kmetiuk

I can seem to figure out the setting to stop it from doing this really think infill with overlap that clogs the nozzle destroys the print. I can get around it by adding more perimeters, but this seems like something that I am probably missing in the settings. s3D clogging.PNG The slizer keeps crammi...

Search found 4 matches

Re: ULTRA THIN INFILL !!!! This keeps clogging my nozzle.

Re: ULTRA THIN INFILL !!!! This keeps clogging my nozzle.

Re: ULTRA THIN INFILL !!!! This keeps clogging my nozzle.

ULTRA THIN INFILL !!!! This keeps clogging my nozzle.