Search found 3 matches
- Tue May 21, 2019 4:52 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Small outcroppings are overextruded
- Replies: 5
- Views: 1266
- Jump to post
Re: Small outcroppings are overextruded
Here's the factory file. I'm printing Hatchbox PLA at 170 C, 40mm/s. I've gone down from 210 C in 10 degree increments and this is the best it's been so far.
- Mon May 20, 2019 6:20 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Small outcroppings are overextruded
- Replies: 5
- Views: 1266
- Jump to post
Re: Small outcroppings are overextruded
I've attached the factory file. The material is Hatchbox Silver PLA at 170C going 40mm/s or 2400mm/min. I suspected temperature as well and have tried 210, 200, 190, 180. Most people seem to recommend 210-200 for this filament but I didn't have any luck with those.
- Sat May 18, 2019 11:03 pm
- Forum: Troubleshooting and Bug Reports
- Topic: Small outcroppings are overextruded
- Replies: 5
- Views: 1266
- Jump to post
Small outcroppings are overextruded
I've minimized my over extrusion and the rest of my prints are coming out fine. But whenever I have a small island all by itself, I seem to get a lot of printing issues. Are there any settings in Simplify3D that could improve this? Here are some examples of what I'm talking about. Notice the blobs o...
